Anywave ATSC VHF 100W Посібник із швидкого старту - Сторінка 12

Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Передавач Anywave ATSC VHF 100W. Anywave ATSC VHF 100W 17 сторінок.

7. Continue to slowly raise the FWD power until you reach the full 100W, or your

desired TPO. Be careful to make small increases in the value of POWER as you

approach the desired output level.

8. Check the SNR and Shoulder (LIMD and UIMD) RF performance of your

system on the Exciter hi level status screen, as well as the exciter's pages on the

PA's touchscreen as shown below. Linear and Non-Linear corrections were

already performed and optimized at a TPO of 100W in the factory and so the

stored correction coefficients should produce good results.

ACT-PAVIII1-QSG-DOC-V1.1, 06/26/2018

ATSC VHF 100W Quick Start Guide

Page 12 of 17