Dudley Resan Standard Shelf Instructions de montage - Page 2
Parcourez en ligne ou téléchargez le pdf Instructions de montage pour {nom_de_la_catégorie} Dudley Resan Standard Shelf. Dudley Resan Standard Shelf 3 pages. Through wall mounted installation
Imprimer la pageImportant
Please read these instructions carefully before installation.
Disclaimer
1. The specifications of this product can change without notice as a result of continual product
development.
2. These instructions are intended to be a general guide only as specific conditions vary from
installation to installation.
3. The images in these instructions are for illustrative purposes only and may vary slightly from
the actual product as a result of continual product development.
4. Check the product for defects or damage prior to fitting. Fitting the product is an acceptance
that the product is free from defects and Thomas Dudley Limited cannot retrospectively
accept responsibility for any defects subsequently discovered.
Component Checklist
Through Wall Installation
1. Shelf
2. 3 x M10 threaded fixing studs
3. 3 x M10 lock nuts
4. 4 x M10 washers
5. Paper drilling template
6. Instruction leaflet
Equipment Checklist: Not Supplied
1. Drill and masonry bits suitable to create required holes
2. Adjustable Spanner
3. Spirit level
4. Pencil
Unpacking
1. Unpack the shelf and rest on a soft grit free surface to avoid scratches or other damage to the
surface finish.
2. Check for any defects.
Wall Preparation
1. Ensure that the wall surface where the shelf is to be mounted is vertical, flat and free from
protrusions and debris.
2. Ensure that the wall to which the shelf is fitted is structurally sound and capable of supporting
the 8kg weight of the shelf.
3. Affix the paper drilling template to the wall at a height in accordance with the local
recommended standards using masking tape, ensuring that it is level and crease free.
4. Using a pencil, mark the hole centres for either the 3 off mounting positions.
5. Remove the template and drill holes through the wall as required.
6. Remove all debris from the holes.
12271 Iss1 R327139
2 of 3