Dudley Resan Standard Shelf Montaj Talimatları - Sayfa 2

İç Mekan Mobilyaları Dudley Resan Standard Shelf için çevrimiçi göz atın veya pdf Montaj Talimatları indirin. Dudley Resan Standard Shelf 3 sayfaları. Through wall mounted installation

Sayfayı Yazdır

Important

Please read these instructions carefully before installation.

Disclaimer

1. The specifications of this product can change without notice as a result of continual product

development.

2. These instructions are intended to be a general guide only as specific conditions vary from

installation to installation.

3. The images in these instructions are for illustrative purposes only and may vary slightly from

the actual product as a result of continual product development.

4. Check the product for defects or damage prior to fitting. Fitting the product is an acceptance

that the product is free from defects and Thomas Dudley Limited cannot retrospectively

accept responsibility for any defects subsequently discovered.

Component Checklist

Through Wall Installation

1. Shelf

2. 3 x M10 threaded fixing studs

3. 3 x M10 lock nuts

4. 4 x M10 washers

5. Paper drilling template

6. Instruction leaflet

Equipment Checklist: Not Supplied

1. Drill and masonry bits suitable to create required holes

2. Adjustable Spanner

3. Spirit level

4. Pencil

Unpacking

1. Unpack the shelf and rest on a soft grit free surface to avoid scratches or other damage to the

surface finish.

2. Check for any defects.

Wall Preparation

1. Ensure that the wall surface where the shelf is to be mounted is vertical, flat and free from

protrusions and debris.

2. Ensure that the wall to which the shelf is fitted is structurally sound and capable of supporting

the 8kg weight of the shelf.

3. Affix the paper drilling template to the wall at a height in accordance with the local

recommended standards using masking tape, ensuring that it is level and crease free.

4. Using a pencil, mark the hole centres for either the 3 off mounting positions.

5. Remove the template and drill holes through the wall as required.

6. Remove all debris from the holes.

12271 Iss1 R327139

2 of 3