Duerkopp Adler 558 Manuel d'instructions d'installation - Page 5
Parcourez en ligne ou téléchargez le pdf Manuel d'instructions d'installation pour {nom_de_la_catégorie} Duerkopp Adler 558. Duerkopp Adler 558 14 pages.
Imprimer la page
2. Installation
Prior to installation the following work must be conducted:
–
Remove the transport fastening screw 3 !
The screw is marked red.
–
The needle bar is turned into its low position for transport.
By turning the handwheel 1 in the direction of the arrow bring the needle bar into
the high position !
–
Push on crank handle 2 and lock in place !
2.1 Transport
For in-house transport the machine must be lifted and transported on a suitable wagon
(e.g. pallet truck).
2.2 Work Height
The work height is adjustable between 76 and 104 cm.
The machine was set at a work height of 82 cm at the factory.
–
Loosen screws 4.
–
Set the machine horizontally at the desired work height.
–
Tighten screws 4.
2.3 Shift Linkage
The shift linkage from the hand shift lever to the pedal is to be set appropriate to the
work height.
–
Loosen screw 5.
–
Set the pedal.
The operator must be able to switch off the machine unhindered by stepping
forward on the pedal.
–
Tighten screw 5.
ATTENTION !
The buttonhole machine may only be installed by trained
personnel.
5