Duerkopp Adler 558 Instrukcja instalacji - Strona 5

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Maszyna do szycia Duerkopp Adler 558. Duerkopp Adler 558 14 stron.

2. Installation

Prior to installation the following work must be conducted:

–

Remove the transport fastening screw 3 !

The screw is marked red.

–

The needle bar is turned into its low position for transport.

By turning the handwheel 1 in the direction of the arrow bring the needle bar into

the high position !

–

Push on crank handle 2 and lock in place !

For in-house transport the machine must be lifted and transported on a suitable wagon

(e.g. pallet truck).

The work height is adjustable between 76 and 104 cm.

The machine was set at a work height of 82 cm at the factory.

–

Loosen screws 4.

–

Set the machine horizontally at the desired work height.

–

Tighten screws 4.

The shift linkage from the hand shift lever to the pedal is to be set appropriate to the

work height.

–

Loosen screw 5.

–

Set the pedal.

The operator must be able to switch off the machine unhindered by stepping

forward on the pedal.

–

Tighten screw 5.

ATTENTION !

The buttonhole machine may only be installed by trained

personnel.