Cascade E Series Instructions d'installation

Parcourez en ligne ou téléchargez le pdf Instructions d'installation pour {nom_de_la_catégorie} Cascade E Series. Cascade E Series 2 pages. Push/pull and carpet pole removal and installation
Également pour Cascade E Series : Manuel d'instructions d'installation (14 pages), Manuel d'instructions d'installation (12 pages), Manuel d'instructions d'installation (11 pages), Manuel de l'opérateur (20 pages)

Imprimer la page
c
Installation
Instructions
This sheet provides instructions to remove and install
Cascade Push/Pull and Carpet Pole attachments. Refer to
specific service, installation and operator guides for proper
handling procedures and guidelines.
Carpet Pole Removal and Installation
WARNING: Keep hands and feet away from
pinch points and under the attachment.
1
Lower the attachment onto a pallet. Place the pole on a
block.
2
Disconnect the Quick-Change lower hooks. Pull out the
retaining pins, slide the lower hooks down and install the
retaining pins in the lower hook holes.
3
Lower the truck carriage and back away from the
attachment.
4
For installation, reverse the above procedures except for
the following items:
• Make sure the center locating tab in the upper hook
properly engages the center notch in the upper truck
carriage bar.
• The gap between the lower hook and carriage bar
must not exceed 3/16 in. (5 mm). If gap is excessive,
remove the hook guides and turn them over. Tighten
the capscrews to a torque of 118-125 ft.-lbs.
(160-170 Nm).
• Slide lower hooks up and install retaining pins in the
hook top holes to secure carpet pole on carriage.
4
Center on truck carriage.
Engage upper hook centering
tab in carriage center notch.
AC0666.ill
cascade
corporation
For Technical Support . . .
Call: 1-800-227-2233
Fax: 1-888-329-8207
Internet: www.cascorp.com
Write: Cascade Corporation, PO Box 20187, Portland, OR 97294
E-Series Push/Pull and
Carpet Pole Removal
and Installation
NOTE: Install retaining pins
in the lower hook holes.
Check lower
4
hook gap
3/16 in.
(5 mm)
maximum
AC0664.ill
Hook Guide
e
a d
s c
c a
To Order Parts . . .
Call: 1-888-227-2233
Fax: 1-888-329-0234
Internet: www.cascorp.com
Write: Cascade Corporation, 2501 Sheridan Ave., Springfield, OH 45505
1
Position pole
on a block
AC0665.ill
2
Disconnect
lower hooks.
Raise lower hooks after
placing on truck carriage.
Install pins in upper holes.
5/8 in.
(16 mm)
e
a d
s c
c a
AC0769.ill