Cascade E Series 설치 지침
{카테고리_이름} Cascade E Series에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Cascade E Series 2 페이지. Push/pull and carpet pole removal and installation
Cascade E Series에 대해서도 마찬가지입니다: 설치 지침 매뉴얼 (14 페이지), 설치 지침 매뉴얼 (12 페이지), 설치 지침 매뉴얼 (11 페이지), 운영자 매뉴얼 (20 페이지)
페이지 인쇄c
Installation
Instructions
This sheet provides instructions to remove and install
Cascade Push/Pull and Carpet Pole attachments. Refer to
specific service, installation and operator guides for proper
handling procedures and guidelines.
Carpet Pole Removal and Installation
WARNING: Keep hands and feet away from
pinch points and under the attachment.
1
Lower the attachment onto a pallet. Place the pole on a
block.
2
Disconnect the Quick-Change lower hooks. Pull out the
retaining pins, slide the lower hooks down and install the
retaining pins in the lower hook holes.
3
Lower the truck carriage and back away from the
attachment.
4
For installation, reverse the above procedures except for
the following items:
• Make sure the center locating tab in the upper hook
properly engages the center notch in the upper truck
carriage bar.
• The gap between the lower hook and carriage bar
must not exceed 3/16 in. (5 mm). If gap is excessive,
remove the hook guides and turn them over. Tighten
the capscrews to a torque of 118-125 ft.-lbs.
(160-170 Nm).
• Slide lower hooks up and install retaining pins in the
hook top holes to secure carpet pole on carriage.
4
Center on truck carriage.
Engage upper hook centering
tab in carriage center notch.
AC0666.ill
cascade
corporation
For Technical Support . . .
Call: 1-800-227-2233
Fax: 1-888-329-8207
Internet: www.cascorp.com
Write: Cascade Corporation, PO Box 20187, Portland, OR 97294
E-Series Push/Pull and
Carpet Pole Removal
and Installation
NOTE: Install retaining pins
in the lower hook holes.
Check lower
4
hook gap
3/16 in.
(5 mm)
maximum
AC0664.ill
Hook Guide
e
a d
s c
c a
To Order Parts . . .
Call: 1-888-227-2233
Fax: 1-888-329-0234
Internet: www.cascorp.com
Write: Cascade Corporation, 2501 Sheridan Ave., Springfield, OH 45505
1
Position pole
on a block
AC0665.ill
2
Disconnect
lower hooks.
Raise lower hooks after
placing on truck carriage.
Install pins in upper holes.
5/8 in.
(16 mm)
e
a d
s c
c a
AC0769.ill