3P Technik DTC200 Manuel d'installation et d'utilisation - Page 12
Parcourez en ligne ou téléchargez le pdf Manuel d'installation et d'utilisation pour {nom_de_la_catégorie} 3P Technik DTC200. 3P Technik DTC200 16 pages.
Imprimer la page
Outputs
All 4 outputs can be activated by pressing buttons 1 to 4 on the keypad. The exit this menu you must press
buttons 1 and 4 together and release (or power down the system).
Run
Resume operation. Select this to return to the main operational display when configuration/diagnostic is
finished.
Stop
At any time while the system is running (i.e. not in a menu setting), the operation of the panel, pumps and
solenoid can be halted by pressing STOP. Unlike pressing Menu, this option will activate the BMS output to
indicate that the unit has been halted for a purpose other than configuration. It is expected that this button
may be used by persons with no knowledge of the system and/or no access to the Operation Manual.
Under this setting there are 3 options.
Menu
Enters the main system menu.
Wipe Configuration (Wipe Config)
This option wipes all configuration settings from memory then restarts the system. Default values will then
be loaded and the system will behave as if it were switched on for the first time.
Note – Any options set during commissioning will be lost and need to be re-entered.
Restart
Restarts operation of the system.
DTC200 V1.20
Page 12
22/01/20