3P Technik DTC200 Installation And Operation Manual - Page 12

Browse online or download pdf Installation And Operation Manual for Controller 3P Technik DTC200. 3P Technik DTC200 16 pages.

Print Page

Outputs

All 4 outputs can be activated by pressing buttons 1 to 4 on the keypad. The exit this menu you must press

buttons 1 and 4 together and release (or power down the system).

Resume operation. Select this to return to the main operational display when configuration/diagnostic is

finished.

At any time while the system is running (i.e. not in a menu setting), the operation of the panel, pumps and

solenoid can be halted by pressing STOP. Unlike pressing Menu, this option will activate the BMS output to

indicate that the unit has been halted for a purpose other than configuration. It is expected that this button

may be used by persons with no knowledge of the system and/or no access to the Operation Manual.

Under this setting there are 3 options.

This option wipes all configuration settings from memory then restarts the system. Default values will then

be loaded and the system will behave as if it were switched on for the first time.

Note – Any options set during commissioning will be lost and need to be re-entered.

Restarts operation of the system.

DTC200 V1.20

Page 12

22/01/20