3P Technik DTC200 Installation And Operation Manual - Page 10

Browse online or download pdf Installation And Operation Manual for Controller 3P Technik DTC200. 3P Technik DTC200 16 pages.

Print Page

Startup Screen Menus and Functions

Upon first applying power, the LCD panel will display a startup logo followed by automatic calibration of the

rainwater tank sensor for approximately 3 seconds, and then immediately commence operation. The main

screen displays the following information:

Tank State (Tank Filling/Full/Tank Emptying)

Dosing State (Dosing/Reacting)

Time Remaining if a timed operation is in progress

Menu Options

The last line of the display always shows up to four menu options, which can be selected by pressing one of

the four corresponding buttons beneath the display. The menu options displayed will change as you enter

different areas of the software.

While in the main status screen, button 1 can be used to access the menu for configuration. Whilst in this

area all operation is halted while parameters are being set by the operator. To exit press "Run" or "Exit".

Provides access setup and diagnostic functions, or resume operation by pressing RUN.

Provides access to

1. Dosing Mode

2. Timer Settings

3. Alarm Enable/Disable

By pressing the change button you can switch operation between Dose While Filling or Dose After Filling.

The default setting is Dose After Filling in which the tank is filled, chemical dosing occurs followed by a

reaction delay and the tank is emptied.

Dose While Filling starts the chemical dosing pump as the tank begins to fill and begins the dosing timer.

Once the timer expires the tank will continue to fill and once full the reaction delay will start. In the event

that the tank fills before dosing is completed then the dosing will continue until it's time is completed and

the reaction delay begins. This mode reduces the total duration of the processing cycle.

DTC200 V1.20

Page 10

22/01/20