Danelectro D-5 Instructions - Page 2

Parcourez en ligne ou téléchargez le pdf Instructions pour {nom_de_la_catégorie} Danelectro D-5. Danelectro D-5 2 pages.

D-5 Instructions

TO BEGIN:

• Install 9-Volt battery (included). If using Danelectro's

"Zero Hum" adapter (Recommended) instead of a battery,

connect this to the "9V DC" jack on the back of the D-5.

• Connect an instrument cable from your guitar to the

"Input" jack. Connect a second cable from the "Output"

jack of the D-5 to the input jack of your amplifier.

CONTROL FUNCTIONS:

DEPTH: Adjusts the depth or range of the chorus. Higher

settings will be more extreme, and may require

adjustment of the Speed control to compensate. Lower

settings will be more subtle.

SPEED: Adjusts the speed of the chorus. This control

interacts with the Depth control—slower Speed

settings will allow higher Depth settings. Then again,

you may like the sound of both controls maxed out!

MIX: This control allows you to mix in some dry signal with

the chorused signal. At the lowest setting, there will

be virtually no chorus effect, at maximum, there will

be chorused sound only. Note that the pedal is loudest

when the Mix control is set to maximum.

FAB

Chorus

DEPTH:

Adjusts the depth or

Adjusts the speed

range of chorus

INPUT

BATTERY: Uses one S-006P 9-Volt Battery. Danelectro "Vintage Power

Source" batteries are recommended.

BATTERY ELIMINATOR: Uses 9-Volt Battery Eliminator.

Polarity: Center Negative (-). 300mA maximum. Danelectro "Zero Hum"

Battery Eliminators are recommended.

SPEED:

MIX:

Adjusts the

of chorus

mix level

9V DC

OUTPUT