Danelectro D-5 Instructions - Page 2
Browse online or download pdf Instructions for Music Pedal Danelectro D-5. Danelectro D-5 2 pages.
Print Page
D-5 Instructions
TO BEGIN:
• Install 9-Volt battery (included). If using Danelectro's
"Zero Hum" adapter (Recommended) instead of a battery,
connect this to the "9V DC" jack on the back of the D-5.
• Connect an instrument cable from your guitar to the
"Input" jack. Connect a second cable from the "Output"
jack of the D-5 to the input jack of your amplifier.
CONTROL FUNCTIONS:
DEPTH: Adjusts the depth or range of the chorus. Higher
settings will be more extreme, and may require
adjustment of the Speed control to compensate. Lower
settings will be more subtle.
SPEED: Adjusts the speed of the chorus. This control
interacts with the Depth control—slower Speed
settings will allow higher Depth settings. Then again,
you may like the sound of both controls maxed out!
MIX: This control allows you to mix in some dry signal with
the chorused signal. At the lowest setting, there will
be virtually no chorus effect, at maximum, there will
be chorused sound only. Note that the pedal is loudest
when the Mix control is set to maximum.
FAB
Chorus
DEPTH:
Adjusts the depth or
Adjusts the speed
range of chorus
INPUT
BATTERY: Uses one S-006P 9-Volt Battery. Danelectro "Vintage Power
Source" batteries are recommended.
BATTERY ELIMINATOR: Uses 9-Volt Battery Eliminator.
Polarity: Center Negative (-). 300mA maximum. Danelectro "Zero Hum"
Battery Eliminators are recommended.
SPEED:
MIX:
Adjusts the
of chorus
mix level
9V DC
OUTPUT