Danfoss iC7 Series Manuel d'installation - Page 12

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Danfoss iC7 Series. Danfoss iC7 Series 16 pages. In-bottom/out-back cooling kit for fa09-fa10, frequency converters
Également pour Danfoss iC7 Series : Manuel d'installation (8 pages), Manuel d'installation (8 pages), Manuel d'installation (6 pages), Manuel d'installation (14 pages), Manuel d'installation (16 pages), Manuel d'installation (8 pages), Manuel d'installation (8 pages), Manuel d'installation (10 pages), Manuel d'installation (16 pages), Manuel d'installation (16 pages), Manuel d'installation (6 pages), Manuel d'installation (6 pages), Manuel d'installation (18 pages)

In-back/Out-back Cooling Kit for FA09-FA10

Installation Guide

Top gasket

Front gasket

M5 nut

Front cover

Grill gasket

2.8 Installing the Lower Duct

To attach the lower duct to the frequency converter, use the following steps.

Procedure

Place the strip gasket over the 2 slots at the bottom back of the frequency converter.

Remove the cover and gasket from the bottom of the frequency converter by removing 7 screws.

Retain the screws, but discard the cover and gasket.

Secure the top flange of the duct to the bottom of the frequency converter using the screws removed in step 2.

Refer to

Illustration

Attach the front duct cover.

10. Torque screws to 2.3 Nm (20 in-lb).

Back grill

Side gaskets, left and right

Duct frame

Base gasket

Duct base cover

AN371942471353en-000101 / 136R0248

Installation