Danfoss iC7 Series Panduan Instalasi - Halaman 12

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Penggerak DC Danfoss iC7 Series. Danfoss iC7 Series 16 halaman. In-bottom/out-back cooling kit for fa09-fa10, frequency converters
Juga untuk Danfoss iC7 Series: Panduan Instalasi (8 halaman), Panduan Instalasi (8 halaman), Panduan Instalasi (6 halaman), Panduan Instalasi (14 halaman), Panduan Instalasi (16 halaman), Panduan Instalasi (8 halaman), Panduan Instalasi (8 halaman), Panduan Instalasi (10 halaman), Panduan Instalasi (16 halaman), Panduan Instalasi (16 halaman), Panduan Instalasi (6 halaman), Panduan Instalasi (6 halaman), Panduan Instalasi (18 halaman)

Halaman Cetak
Danfoss iC7 Series Panduan Instalasi
In-back/Out-back Cooling Kit for FA09-FA10
Installation Guide
1
Top gasket
2
Front gasket
3
M5 nut
4
Front cover
5
Grill gasket
2.8 Installing the Lower Duct
To attach the lower duct to the frequency converter, use the following steps.
Procedure
1.
Place the strip gasket over the 2 slots at the bottom back of the frequency converter.
2.
Remove the cover and gasket from the bottom of the frequency converter by removing 7 screws.
Retain the screws, but discard the cover and gasket.
3.
Secure the top flange of the duct to the bottom of the frequency converter using the screws removed in step 2.
Refer to
Illustration
4.
Attach the front duct cover.
12 | Danfoss A/S © 2022.03
10. Torque screws to 2.3 Nm (20 in-lb).
6
Back grill
7
Side gaskets, left and right
8
Duct frame
9
Base gasket
10
Duct base cover
AN371942471353en-000101 / 136R0248
Installation