Danfoss VLT Automation Manuel d'instructions - Page 3

Parcourez en ligne ou téléchargez le pdf Manuel d'instructions pour {nom_de_la_catégorie} Danfoss VLT Automation. Danfoss VLT Automation 16 pages.

Install gasket material on the back openings of

the drive (Photo 2) prior to installation on the en-

closure back panel.

D3 and D4 frames: Use the template provided

with the kit (175R5639) to determine the drive

location on the back panel of the enclosure. The

template is referenced to the top-left corner of the

back panel. Therefore the template may be used

with any size back panel and both the 1800 mm

and 2000 mm high enclosures.

E2 frame: Use the measurements on Drawing

175F1037, Sheet 2 to determine the drive loca-

tion.

Prior to installing the back panel in the enclosure,

apply the gasket on both sides of the bottom duct

adapter as shown in Photos 3 and 4.

Photo 3. Bottom duct adapter

Instruction No: 175R5640 V3

Aug 13, 2008

Page 3

Photo 2. Drive open-

ings on rear are not

used in this applica-

tion.

Photo 4. Bottom duct adapter w/