Danfoss VLT Automation 사용 설명서 - 페이지 3

{카테고리_이름} Danfoss VLT Automation에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Danfoss VLT Automation 16 페이지.

Install gasket material on the back openings of

the drive (Photo 2) prior to installation on the en-

closure back panel.

D3 and D4 frames: Use the template provided

with the kit (175R5639) to determine the drive

location on the back panel of the enclosure. The

template is referenced to the top-left corner of the

back panel. Therefore the template may be used

with any size back panel and both the 1800 mm

and 2000 mm high enclosures.

E2 frame: Use the measurements on Drawing

175F1037, Sheet 2 to determine the drive loca-

tion.

Prior to installing the back panel in the enclosure,

apply the gasket on both sides of the bottom duct

adapter as shown in Photos 3 and 4.

Photo 3. Bottom duct adapter

Instruction No: 175R5640 V3

Aug 13, 2008

Page 3

Photo 2. Drive open-

ings on rear are not

used in this applica-

tion.

Photo 4. Bottom duct adapter w/