3W M20M200 Manuel - Page 7
Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} 3W M20M200. 3W M20M200 9 pages.
o
Synchro Mode in case of a double bed
This motors can also be connected to remote controls TOPLINE in a 'synchro' way;
in the Synchro Mode both bed parts will be adjusted at the same time by one single
remote. This by using the optional Synchro Cable.
•
Connect the synchro cable (X-cable - male socket) to both motors. This in the
7-pole socket, next to the connecting button A.
•
The synchro function is activated by default after connecting the Synchro
Cable.
Programming MEMORY positions
You can store 2 positions of the bed in the memory using the M1 and M2
•
keys.
•
Put the bed in a position you want to store.
Press programming key D until the buttons M1 and M2 light up (after 3 sec.).
•
Now press M1 or M2 to store the current position.
•
•
The white LED on the motor flashes 2 x and will go out. The position was
stored.
PROBLEM CASE: Reset of the receiver (factory settings)
If problems occur during the installation of the motor and the remote controls you
may reset the receiver and repeat the connecting procedure:
HOW TO RESET THE RECEIVER:
Press 4 x the connecting button A of the motor until the LED light goes on,
•
afterwards please press a 5th time.
•
The white LED flashes 2 x and will go out. The receiver went back to the
original factory settings.
•
The connecting procedure between remote and receiver can now be
executed as described above.
moving to their Zero Position. When the white LED light on the
motor flashes 2 x, the reference movement was successful.
The adjustable bed is now ready to be used.