Danfoss iC7 Series Manuel d'installation - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Danfoss iC7 Series. Danfoss iC7 Series 8 pages. In-bottom/out-back cooling kit for fa09-fa10, frequency converters
Également pour Danfoss iC7 Series : Manuel d'installation (8 pages), Manuel d'installation (6 pages), Manuel d'installation (14 pages), Manuel d'installation (16 pages), Manuel d'installation (8 pages), Manuel d'installation (8 pages), Manuel d'installation (10 pages), Manuel d'installation (16 pages), Manuel d'installation (16 pages), Manuel d'installation (6 pages), Manuel d'installation (6 pages), Manuel d'installation (16 pages), Manuel d'installation (18 pages)

IGBT Module Replacement for Fx09-Fx12 and E1h–E4h

Installation Guide

Place the IGBT module on the heat sink by aligning the mounting holes in the module to those in the heat sink. Refer to

Illustration

Illustration 2: Mounting the IGBT Module on the Heat Sink

IGBT module fastener

IGBT modules

Insert the mounting screws and hand tighten them.

The IGBT module requires either 4 or 10 screws to fasten it to the heat sink.

Following the fastener tightening sequence shown in

the torque values listed in

Repeat the same tightening sequence and slowly tighten (maximum 5 RPM) all screws to 100% of the torque value.

Illustration

Table 7

and

Table

Brake IGBT modules

Plastic IGBT mounting frame

3, slowly tighten (maximum 20 RPM) all screws to 50% of

AN361427984575en-000101 / 130R0770 | 5

Installation