Daniela DAN6FGS Manuel d'installation et d'utilisation - Page 11

Parcourez en ligne ou téléchargez le pdf Manuel d'installation et d'utilisation pour {nom_de_la_catégorie} Daniela DAN6FGS. Daniela DAN6FGS 20 pages.

OVEN DOOR REMOVAL

The oven door can be removed to give easier access

to the oven when cleaning.

To remove, proceed as follows:

• Open the oven door and insert rivet or nail (R) in the

hole (F) of the hinge (fig. E).

• Partially close the door, forcing it upwards at the

same time to free stop tooth and hinge sector.

• Once the hinge is free, pull the door forwards tilting

it slightly upwards to free sector.

• To reassemble proceed in the reverse order, paying

attention to the correct position of sectors.

INTERNAL OVEN DOOR GLASS

One of the features of our ovens is that the internal

oven door glass can be easily removed for cleaning

without the aid of specialized personnel.

Just open the oven door and extract the support to

which is attached the glass (fig. F).

ATTENTION!! This operation can also be carried

out while the door is assembled on the appliance,

however in this case, with the door horizontally

hinged take the utmost care when extracting

the glass upwards, the force of the hinges can

suddenly snap the door shut.

Some problems can be caused either as the results of simple maintenance operations or by incorrect selection

of settings. Prior to contacting a Service Engineer please check the following chart.

PROBLEM occurring

The oven does not work

The thermostat is not working

The oven light does not switch on

In case the appliance fails to operate correctly, contact our Service Centre.

Warning: Servicing should be carried out only by authorised personnel.

INSTRUCTIONS FOR THE USER

TROUBLESHOOTING

• Make sure the gas cock is open

• Check that the plug is connected.

• Check the electrical system (fuse electricity board). If there is failure

in the system call an electrician.

• Contact Service Centre..

• Check that the oven bulb is properly fitted

• If it has blown, buy a bulb specifically for high temperatures at a

Service Centre and fit it following the instructions given on page 12.

�

SOLUTION envisaged

�