Daniela DAN6FGS 설치 및 운영 매뉴얼 - 페이지 11

{카테고리_이름} Daniela DAN6FGS에 대한 설치 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Daniela DAN6FGS 20 페이지.

Daniela DAN6FGS 설치 및 운영 매뉴얼
OVEN DOOR REMOVAL
The oven door can be removed to give easier access
to the oven when cleaning.
To remove, proceed as follows:
• Open the oven door and insert rivet or nail (R) in the
hole (F) of the hinge (fig. E).
• Partially close the door, forcing it upwards at the
same time to free stop tooth and hinge sector.
• Once the hinge is free, pull the door forwards tilting
it slightly upwards to free sector.
• To reassemble proceed in the reverse order, paying
attention to the correct position of sectors.
INTERNAL OVEN DOOR GLASS
One of the features of our ovens is that the internal
oven door glass can be easily removed for cleaning
without the aid of specialized personnel.
Just open the oven door and extract the support to
which is attached the glass (fig. F).
ATTENTION!! This operation can also be carried
out while the door is assembled on the appliance,
however in this case, with the door horizontally
hinged take the utmost care when extracting
the glass upwards, the force of the hinges can
suddenly snap the door shut.
Some problems can be caused either as the results of simple maintenance operations or by incorrect selection
of settings. Prior to contacting a Service Engineer please check the following chart.
PROBLEM occurring
The oven does not work
The thermostat is not working
The oven light does not switch on
In case the appliance fails to operate correctly, contact our Service Centre.
Warning: Servicing should be carried out only by authorised personnel.
INSTRUCTIONS FOR THE USER

TROUBLESHOOTING

• Make sure the gas cock is open
• Check that the plug is connected.
• Check the electrical system (fuse electricity board). If there is failure
in the system call an electrician.
• Contact Service Centre..
• Check that the oven bulb is properly fitted
• If it has blown, buy a bulb specifically for high temperatures at a
Service Centre and fit it following the instructions given on page 12.
SOLUTION envisaged
11
E
F