Danley DTS20 Manuel du propriétaire - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Danley DTS20. Danley DTS20 8 pages.

that may decrease the strength of the subwoofer enclosure. Accessory rigging hardware provided with or for Danley subwoofers

must be inspected for fatigue at least annually. The inspection shall include a visual material survey for signs of corrosion, bending

or any other condition that may decrease strength of the fastener. For other fittings used, refer to the manufacturer's inspection

and maintenance guidelines for process.

Danley Sound Labs is not responsible for the application of its products for any purpose or the misuse of this information for any

purpose. Furthermore, Danley Sound Labs is not responsible for the abuse of its products caused by avoiding compliance with

inspection and maintenance procedures or any other abuse. Prior to suspending the system, an expert, trained and experienced

in flying subwoofer systems should inspect all rigging parts and components.

SECTION 4

4.1

Acoustic Level Warning

Danley Sound Labs subwoofers can produce sound levels capable of causing permanent hearing damage from prolonged

exposure. The higher the sound level, the less exposure needed to cause such damage. Avoid prolonged exposure to the high

sound levels from the subwoofer. Some are capable of levels in excess of 130 dBSPL! Levels this high can cause permanent

hearing loss! When operating at these high sound pressure levels the user is strongly encourages to use hearing protection. Danley

Sound Labs accepts no liability for hearing damage from using our subwoofers!

4.2

Operator Responsibility

It is the responsibility of the operator to maintain safe operating levels and to insure that the audience is not harmed by excessive

levels. This is a chart of the recommended exposure limits set by OSHA.

4.3

Aqua Tight Coating

Aqua Tight Coating includes full two layer fiberglass finish for maximum moisture resistance as well as a special polyurea coat

bonded to the fiberglass exterior & two topcoat layers of UV resistant color stabilizer. It also includes all stainless steel exterior

fasteners, an acoustically transparent moisture barrier to the grille, waterproofing the driver cones and sealant for the input plate,

handles or cabinet fixtures. The finish also includes a powder coated stainless steel grille, sealed, waterproof cable leads (12'

length standard), and fully caulked all external joints (except for the "weep" opening at the bottom of the grille).

If a repair is to be made on a loudspeaker with "AT" finish, a few steps must be taken to insure the speaker remains water

resistant in future usage. The caulking must be removed to free the grill and driver access panels. Once the repair is finalized,

the bolts must be coated with silicon and the caulk must be replaced on all panels that have been removed.

Page | 6

DANLEY OWNER'S MANUAL

Operation