Caslon Rollataq Manuel d'utilisation et d'entretien - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation et d'entretien pour {nom_de_la_catégorie} Caslon Rollataq. Caslon Rollataq 8 pages.

Start Up

Applying adhesive

1. Turn on the motor switch located at the front of the machine. Feed the print in with one

hand and catch it as it comes out with the other hand. Do not let the print drop down as it

exits. Turn off the motor after coating the print.

for more than five minutes at a time or it will overheat and cut out. The motor will only start

to operate again when it has cooled down.

2. For longer prints, such as posters, take the leading edge as it exits and guide the print

back towards the front of the Rollataq. The small upper roller will assist with guiding the

poster back towards the operator.

3. After coating you have approximately 1to1.5 minutes to mount the print before the adhesive

starts to dry. Position the print on your substrate and smooth it down to make contact and

remove any air. You can then use a burnishing roller to complete the final smoothing and

removal of air.

Page 5

Place the Rollataq on a level surface and connect the machine to an

approved outlet. Roll back or remove the black vinyl cover from the

Velcro backing. The cover should be replaced when the machine is

not being used as it keeps the adhesive fresh.

Space the stripper fingers 4cms apart as these are used to strip the

print away from the adhesive roller.

Pour the adhesive into the rear of the tray until the level reaches the

upper label (full). There is also an 'add level' label.

: the motor should not be left running