Caslon Rollataq Manuel d'utilisation et d'entretien - Page 8

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation et d'entretien pour {nom_de_la_catégorie} Caslon Rollataq. Caslon Rollataq 8 pages.

Maintenance

Page 7

When you have finished coating, replace the black vinyl cover

over the machine to reduce the thickening of the adhesive in

the tray.

Over a period of time (3-7 days depending on humidity and the

quantity of adhesive in the machine) the adhesive in the tray

will start to thicken. If this happens, thin the adhesive by

adding some fresh adhesive into the tray.

If the adhesive gets very thick, then it should be removed and

the machine cleaned.

Remove the screws on both ends of the coater.

Holding the top roller, swivel the coating roller up and out of

the tray.

There are two support plates attached to the back arm which

have a V groove in them. Hook the V groove to the steel base,

to keep the assembly up.

Leave the roller in the up position allowing the adhesive to

drip from the roller. Lift the roller up, remove the tray and

clean it. Lower the roller down and run paper through the

machine to remove any excess adhesive. You do not have to

clean it perfectly as any adhesive on the roller will dissolve

when the roller runs in fresh adhesive.

If you are not going to use the machine for an extended

period of time you can cover the adhesive tray with the spare

tray supplied. This will keep the adhesive fresh for up to two

weeks. (note: stackable plastic trays in 24" model only, not

36")