3xLogic VISIX VX-VSS-20 Manuel de démarrage rapide - Page 10
Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} 3xLogic VISIX VX-VSS-20. 3xLogic VISIX VX-VSS-20 14 pages. Stereoscopic people counting camera
Imprimer la page
4.2
Counting Configuration
CONFIGURATION FOR SINGLE CAMERA
To configure the camera's people counting, login to the camera's web interface (enter the camera IP address identi
fied in Section 3.2 into a web browser URL bar, enter credentials and click Login) and follow the below instruction t
o configuring people counting:
1. Enable People Counting: Navigate to Configuration>People Counting and toggle Enable People
Counting.
2. Calibration: Select the green Calibration Area box, drag it to proper location and click Calibration.
After this, the Height value on the configuration page will refresh (close to the real height). A red
Counting Area box will deploy as well as a yellow Detection line. The arrows indicate the directional
entrance/exit. See the example below for more detail:
Note: If auto calibration fails, switch to [Manual] and input the measured "Height", then
click [Calibration].
3. Detection line: Move the detection line to the proper location (about 0.5m from the door). Adjust the
length of detection line to the door's width by dragging the line ends. See the below example for
reference:
4. Save and Test Configuration: After configuration, click Save and begin testing the camera's count
accuracy. If the camera's count is inaccurate, slightly adjust the detection line's location and length
until the desired results are achieved.
12000 Pecos Street, Suite 290, Westminster, CO 80234 | www.3xlogic.com | (877) 3XLOGIC
VISIX Stereoscopic People Counting Camera | Quick Start Guide | VX-VSS-20
Figure 4-3 Calibration
Figure 4-4 Configuring Detection Line
10