3xLogic VISIX VX-VSS-20 빠른 시작 매뉴얼 - 페이지 10

{카테고리_이름} 3xLogic VISIX VX-VSS-20에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3xLogic VISIX VX-VSS-20 14 페이지. Stereoscopic people counting camera

4.2

Counting Configuration

To configure the camera's people counting, login to the camera's web interface (enter the camera IP address identi

fied in Section 3.2 into a web browser URL bar, enter credentials and click Login) and follow the below instruction t

o configuring people counting:

1. Enable People Counting: Navigate to Configuration>People Counting and toggle Enable People

Counting.

2. Calibration: Select the green Calibration Area box, drag it to proper location and click Calibration.

After this, the Height value on the configuration page will refresh (close to the real height). A red

Counting Area box will deploy as well as a yellow Detection line. The arrows indicate the directional

entrance/exit. See the example below for more detail:

Note: If auto calibration fails, switch to [Manual] and input the measured "Height", then

click [Calibration].

3. Detection line: Move the detection line to the proper location (about 0.5m from the door). Adjust the

length of detection line to the door's width by dragging the line ends. See the below example for

reference:

4. Save and Test Configuration: After configuration, click Save and begin testing the camera's count

accuracy. If the camera's count is inaccurate, slightly adjust the detection line's location and length

until the desired results are achieved.

12000 Pecos Street, Suite 290, Westminster, CO 80234 | www.3xlogic.com | (877) 3XLOGIC

VISIX Stereoscopic People Counting Camera | Quick Start Guide | VX-VSS-20

Figure 4-3 Calibration

Figure 4-4 Configuring Detection Line