aevit VIC 2.0 Manuel d'installation et d'utilisation - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel d'installation et d'utilisation pour {nom_de_la_catégorie} aevit VIC 2.0. aevit VIC 2.0 17 pages. Voice interactive controls

Imprimer la page

VIC 2.0 InstAllAtIon

InstAllAtIon stEP 4A - tWo sPEAKERs

Connect the 8-cond speaker cable to the VIC 2.0

CPU and route the cables to the individual speak-

ers.

When VIC 2.0 is activated, the VIC 2.0 CPU sup-

plies enough power to drive TWO vehicle speak-

ers. EMC recommends that you interface directly

with the two front dash speakers or front door

speakers if no dash speakers are available. Be-

cause the OEM vehicles have several different au-

dio options available for each vehicle which, may

or may not include an additional power amplifier,

EMC does NOT include vehicle specific wiring diagrams for the VIC 2.0 system. The left and right

front speaker wires will need to be cut At tHE sPEAKER. This will leave (4) wires, (2) radio side (RS)

and (2) speaker side (SS) on both the right and left sides of the vehicle. The connection to the speak-

ers MUst be on the final pair of wires that are routed to the speakers. These wires may be connected

directly the back of the radio, or an additional power amplifier which may be located under the front

seat or in the rear of the vehicle. The connection CAnnot be on the signal wires that are routed

from the radio to the power amplifier (if one is installed). If vehicle schematics are available, use them

to match the VIC speaker wire polarity with the vehicle speaker polarity.

Locate the two front speakers and cut the two wires to each speaker so you have a vehicle side (VS)

and a speaker side (SS). Strip the wire back approx. 3/8 in, solder and heat shrink the VIC 2.0 speaker

cable wires according to the diagram below:

HARnEss WIRE

PIn #

ColoR

WHITE

YELLOW

VIOLET

BLUE

� � � � � � � � � � � �

FUnCtIon

+ LEFT (SS)

- LEFT (SS)

+ RIGHT (SS)

- RIGHT (SS)

� � � � � � � � � � � � � � � � � � � � � � � � �

� � � �

� � � � �

PIn #

� � � �

� � � � � � � � � � � �

� � � � �

� � � � � � � � � � � �

HARnEss WIRE

FUnCtIon

ColoR

RED

+ LEFT (RS)

BLACK

- LEFT (RS)

ORANGE

+ RIGHT (RS)

GREEN

- RIGHT (RS)

VIC 2.0 INSTALL MANUAL

3-2A