audiophony Brick 120 Manuel de l'utilisateur - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} audiophony Brick 120. audiophony Brick 120 8 pages. Weatherproof bluetooth speaker system

BRICK120 - Weatherproof Bluetooth

6 - Troubleshooting

Problem
Cannot connect my speaker to a
Bluetooth
®
source
Reading stops suddenly
L'enceinte s'éteint toute seule
No sound comes out
The sound is hashed.
Sound does not come out on my
speaker but only on my source
My interlocutors can't hear me
Important note on battery use
It is recommended to charge the battery as soon as the indicator LED(5) flashes red.
If you have not used your speaker for several weeks, the light may not come on. In this case proceed to a
complete charging cycle.
We recommend that you charge the battery at least once every three months.
For your safety be very careful if you use your BRICK120 on public roads. The noise level must be adjusted
so that it is not cut off from its surroundings and can react to traffic around you. The regulations in force must
be observed in compliance with road safety regulations.
®
speaker system
Make sure the speaker is in Bluetooth
indicator LED (4) should flash blue.
Turn off the speaker. Remove it from the Bluetooth
your source. Pair again.
Make sure the battery is charged.
Otherwise, connect your BRICK120 to the supplied AC adapter
until the battery is fully charged.
Adjust the sound level
Make sure your Bluetooth
playback mode.
Check that you are within the Bluetooth
transmitter (about 10m max).
Make sure that you have paired your speaker and that it is selected
as the audio device on your source.
Check that the microphone opening on the front of the speaker is
not obstructed to better capture your words.
Check the reception quality of the telephone network
Prolonged uses of your speaker at maximum
volume may damage your hearing.
Solution
®
mode, the Bluetooth
®
device is properly connected and in
®
signal range of your
WARNING
®
status
®
device list of
Page 7