audiophony Brick 120 사용자 설명서 - 페이지 7
{카테고리_이름} audiophony Brick 120에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. audiophony Brick 120 8 페이지. Weatherproof bluetooth speaker system
페이지 인쇄BRICK120 - Weatherproof Bluetooth
6 - Troubleshooting
Problem
Cannot connect my speaker to a
Bluetooth
®
source
•
Reading stops suddenly
•
L'enceinte s'éteint toute seule
No sound comes out
The sound is hashed.
Sound does not come out on my
speaker but only on my source
My interlocutors can't hear me
Important note on battery use
It is recommended to charge the battery as soon as the indicator LED(5) flashes red.
If you have not used your speaker for several weeks, the light may not come on. In this case proceed to a
complete charging cycle.
We recommend that you charge the battery at least once every three months.
For your safety be very careful if you use your BRICK120 on public roads. The noise level must be adjusted
so that it is not cut off from its surroundings and can react to traffic around you. The regulations in force must
be observed in compliance with road safety regulations.
®
speaker system
•
Make sure the speaker is in Bluetooth
indicator LED (4) should flash blue.
•
Turn off the speaker. Remove it from the Bluetooth
your source. Pair again.
•
Make sure the battery is charged.
•
Otherwise, connect your BRICK120 to the supplied AC adapter
until the battery is fully charged.
•
Adjust the sound level
•
Make sure your Bluetooth
playback mode.
•
Check that you are within the Bluetooth
transmitter (about 10m max).
•
Make sure that you have paired your speaker and that it is selected
as the audio device on your source.
•
Check that the microphone opening on the front of the speaker is
not obstructed to better capture your words.
•
Check the reception quality of the telephone network
Prolonged uses of your speaker at maximum
volume may damage your hearing.
Solution
®
mode, the Bluetooth
®
device is properly connected and in
®
signal range of your
WARNING
®
status
®
device list of
Page 7