AudioSource SS Five Manuel du propriétaire - Page 3

Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} AudioSource SS Five. AudioSource SS Five 6 pages. Surround sound processor with rear and center channel amplifiers, plus remote control

Imprimer la page

Model SS Five

Surround Sound Processor

Monitor

Power

Hall

Power

Matrix

Hall

Surround

Phantom

Test

Monitor

Matrix

Test

Dolby

Phantom

Surround

Using the Controls

The Audiosource SS Five is controlled entirely from the remote control, with the exception

of the Input Level "pop-up" knob on the front panel. For each and every button on the remote

control, there is a red L.E.D. status indicator on the front panel of the SS Five to verify that the

commands from the remote control have been received

Power

Use the remote control to turn the SS Five "ON" or "OFF". A red lamp indicates when the

unit is "ON."

Modes

There are three different modes: Dolby Surround, Hall and Matrix. These determine what type

of decoding or processing the SS Five will employ. Use the buttons on the remote control to

activate each mode. A red LED will glow to verify your choice. Selecting the right mode will

allow you to enjoy multi-speaker sound no matter what the source.

Dolby Surround: Decodes and restores the Dolby Surround information of any source; video

tapes, laser discs, television, compact discs, etc.

Hall: Creates a concert hall ambience from non-Dolby but stereo program material. The rear

speakers contribute to the spaciousness of the effect.

Matrix: Synthesizes a stereo image from mono signals that will play through all of the

speakers.

Phantom

If a center channel speaker is not available, the SS Five will create a "Phantom" center image

by sending these sounds equally to the left and right speakers. The lamp stays off during

normal operation, and is lit to indicate Phantom operation. Please note: If you are not using a

center channel speaker that is connected to the center speaker terminals, be sure to turn off the

center channel amplifier. Refer to Rear Panel Controls on the next page.

Test

The Test function allows you to quickly and accurately set the levels for each of the speakers,

without relying on an input signal. Pressing the button so that the LED is lit sends a tailored

pink noise signal to each speaker in a rotating order. The LED Display will indicate which

speaker is receiving the test signal. The buttons on the remote control may be used to set the

levels. Set all the levels so that they appear to have the same volume. The Test function is only

active in the Dolby Surround mode.

Monitor

On the SS Five, the Monitor function disables the "Line In" on the back panel, and activates

the "Tape In". In effect, the Monitor button becomes an input selector. If no unit is connec-

ted to the "Tape In", selecting the monitor function will act as a "Mute" switch.

-5

-10

Input Level

Down

Rear

Center

Master Volume

Remote Sensor