AudioSource SS Five Manuel du propriétaire - Page 4
Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} AudioSource SS Five. AudioSource SS Five 6 pages. Surround sound processor with rear and center channel amplifiers, plus remote control
Model SS Five
Surround Sound Processor
Monitor
Power
Hall
Using the Controls
Meters
The SS Five features four LED meters; S = Surround, L = Left, C = Center, R = Right. The
meters as a group perform three separate functions. Primarily, they are input meters, and will
display how much signal is present in each channel. This information can be extremely useful,
for example in determining if any surround information is present during a certain scene of a
movie. This is the normal mode for the meters. In addition, the meters will also display the
relative volume settings assigned to each channel, by touching any of the three volume controls.
Finally, in the Test mode, the meters will indicate which speaker is receiving the test signal.
Input Level
The input level knob is used for just that, setting the input level. It is NOT a volume control.
Normally, this knob will be turned 1/2 to 3/4 of the way up. When set properly, the top row
of the meters should faintly flicker during the loudest passages from your source. When the
proper level has been set, push the knob IN. This will lock the knob in it's proper position.
Volume Controls
Use the remote control for the Rear, Center, and Master volume adjustments. When the
remote control buttons are momentarily pressed, the meters will display the relative
volume settings for each channel. Pressing the button again, or continuing to depress
the button for a few seconds, will cause that switch to become active and a new level
may be set. After a new level has been set, the meters will remain in the relative volume
mode for a few seconds longer, and then switch back to their normal mode.
Rear: Raises or lowers the volume level of the Rear Channel in relation to the other speakers.
Center: Raises or lowers the volume level of the Center Channel in relation to the other
speakers.
Master Volume: Raises or lowers the overall volume of the entire system, including the level
of the signal being sent to your other components.
Remote Sensor
This infrared "eye" should be kept unobstructed so that it may "see" the commands from the
Remote Control.
Rear Panel Controls
Center Speaker On / Off
If no center speaker is being used turn this switch off, and turn the Phantom switch on the front
panel On. Also turn the Center Speaker switch Off if the center speaker is being used with
an external amplifier.
Auto or Manual On / Off
The power control has two positions; Manual and Auto. In the "Manual" position, use your
remote control to turn the power ON or OFF. In the "Auto" position, whenever a signal is
detected at the inputs, the SS Five will automatically turn itself "ON". If no signal is detected
over a period of minutes, the SS Five will automatically turn itself "OFF". This allows the user
to bypass the "POWER" switch during system start-up and shut-down.
Matrix
Test
Dolby
Phantom
Surround
S
+6
+3
0
-5
-10
Input Level
L
C
R
Up
Down
Rear
Center
Master Volume
Remote Sensor
+6
+3
0
-5
-10
S
L
C
R
Input Level
Rear
Centre Master
Vol+
Vol+
Vol+
Vol–
Vol–
Vol–
Remote Sensor
CENTER SPEAKER
ON
OFF
AUTO
MANUAL
ON/OFF
3.