DAPAudio CS-850S Manuel - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} DAPAudio CS-850S. DAPAudio CS-850S 12 pages.

CS-850S

Installation

Before installing the DAP CS-850S, ensure that the chosen location on the ceiling is free of any

obstructions such as pipe work, ducting or wiring. In existing constructions, if no crawlspace is available,

use a stud-finding tool to map the ceiling construction and a pipe detector to scan the installation

location. Avoid mounting the subwoofer in close proximity to in-ceiling lighting. This will help to reduce

unwanted vibrations.

Switch off the electric power in the area where the speaker will be mounted prior to installation!

To install the DAP CS-850S, proceed as follows:

01) Remove the outer ring from the supplied cut out template. The inner ring of the template can be

used to protect the speaker during painting.

02) Use the template to mark a cut line on the ceiling. Make sure the cut line has the correct diameter

(230 mm).

03) Cut along the line with an appropriate tool to create a round hole in the ceiling. The flange of the

speaker will cover any imperfections in the cut.

04) Pull the speaker cable down through the hole. Leave about 1,5 m spare cable to ease the

connection of the speaker.

05) Rotate the mounting clamps (04) on the subwoofer counterclockwise and push them downwards to

release them, as shown on Fig. 02 and 03.

06) Push the quick-turn mounting screws (05) on all 3 mounting clamps (04) towards the back of the

grill (03), as shown on Fig. 04. The grill will come off.

07) Remove the grill (03).

08) Connect the speaker cable to the wire terminals on the speaker. Make sure the speaker connection

polarity is correct. See Speaker Wiring on page 7.

Order code: D6588

Fig. 02

Fig. 04

Fig. 03