DAPAudio D2141 Manuel - Page 9

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} DAPAudio D2141. DAPAudio D2141 18 pages.

Installation

Remove all packing materials from the Xenon. Check that all foam and plastic padding is removed. Connect

all cables.

Always disconnect from electric mains power supply before cleaning or servicing.

Damages caused by non-observance are not subject to warranty.

1. DJ Microphone Connector

This jack is used to connect a microphone to the mixer. Connect you microphone via

1/4 inch (6.3mm) or balanced XLR jack.

2. GAIN

Mic Channel input level is determined by the Gain control.

With the Gain control you can adjust the MIC input-sensitivity, while optimally

matching the incoming signals to the mixer's internal operation level. When dealing

with very low input levels (example vocal recordings or distant sound sources) the

high gain is extremely profitable.

How to set the Input level:

1) Set the gain control and the corresponding channel fader to their minimum setting.

2) Play the sound source at its highest volume setting; respectively, sing or speak as

loud as possible directly into the microphone.

3) While doing so, adjust the input level using the gain control, so that during the

loudest passages the PEAK LED is just not lit, but the SIGNAL-LED lights

constantly.

This basic channel setting leaves you at least 8dB headroom. This means, you have

at least 8dB before signal clipping. If you want to make further adjustments to the

channel's EQ setting, you should repeat step 3 and 4 again.

3 / 4 / 5. Equalizer SECTION (HI / MID / LOW)

The mixer's Equalizer section allows shaping of the incoming audio signal. All mono

input channels are fitted with 3-band EQ. The upper (3) and lower (5) shelving

controls have their frequencies fixed at 12 Khz and 80 Hz respectively. The Mid range

control (4) has a peaking response frequency at 1.2 Khz. All 3 bands have up to

12 dB cut and boost, with a centre detent for "OFF". Turning the Equalizer level

control to the right amplifies the frequency range, turning to the left attenuates the

signal. Minor changes to the Equalizer control usually produce the best results. Try to

avoid excessive enhancement of the MID band.

6. Pan

You can pan the Mic signal from Left to Right.

7. Level

This control allows you to adjust the max. output level of the Mic Channel.

8. Talkover Button

When engaged this function will decrease all signal levels, except the microphone and

the channel 1 level, by talkover adjustment. A red LED inside the Talkover Button will

glow when the talkover function is engaged. In the OFF position all signals will remain

at their normal levels.

9. Talkover Control

This knob is used to adjust attenuation level when TALKOVER BUTTON set in the

ON position.