APlusLift MT1500 Manuel d'installation et instructions d'utilisation - Page 12

Parcourez en ligne ou téléchargez le pdf Manuel d'installation et instructions d'utilisation pour {nom_de_la_catégorie} APlusLift MT1500. APlusLift MT1500 20 pages. Motorcycle lift

Imprimer la page

I nst a lla t ion

4 .

4.2 ASSEMBLY INSTRUCTIONS

NOTE: For additional references to the parts listed in the following pages, refer to the

Assembly Diagrams on pages 12 - 14.

4.3 Determine T he Proper Lift Location:

1. Do not use the lift on any asphalt surface. Make sure the lift is used on a dry, oil/grease free,

flat, level, concrete surface capable of supporting the weight of the Lift and the equipment. Do

not use the lift on concrete expansion seams or on cracked, defective concrete.

2. Make sure to check the desired location for possible obstructions such as a low ceiling,

overhead lines, adequate working area, access ways, exits, etc.

4.4 Unpacking & Setup

Open the shipping container, then remove the ramp and shipping boards out of the packaging.

CAREFU LLY T U RN TABLE U PRI GH T I N T O OPERAT I N G POSI T I ON BEFORE

REM OV I N G T H E SH I PPI N G WI RE ON T H E CABLE REST RAI N T FROM

SCI SSOR M ECH AN I SM .

MAKE SURE THAT THE ROLLER GUIDES CONNECTED TO THE

CYLINDER ROD ARE ON THEIR TRACKS CORRECTLY BEFORE RAISING

THE LIFT!

Connect the foot-operated air valve to 90-120 psi air supply. The lift may be damaged and/

or personal injury may result if the pressure exceeds the maximum psi rating.

Stand clear of the lift table, and depress the UP side of the foot valve to raise the table.

To lower the table, raise lift and then lift the safety lock bar from safety latch and lower to

the next position or to the floor.

Place the dropout cover over the dropout opening.

Insert the ramp mounting pins into the holes at the end of the table to mount the approach

ramp.

The safety lock bar can be held up by attaching it to the safety lock bar clip underneath the

table assembly.

2020

www.apluslift.com

Phone: 800-616-9618 Text: 425-300-2600 Email: [email protected]

APlusLift MT1500 & MT1500X

I N ST ALLAT I ON M a nua l

Route hose from here ONLY.

Otherwise clearance may not

be enough.

Figure 4.1

Mounting points for the

MT1500

MT1500X

ramps. Please make sure the approach

ramp is

correctly

mounting points before using the lift table.

APlusLift

approach

installed

all

12 of 20