APlusLift MT1500 Kurulum Kılavuzu ve Çalıştırma Talimatları - Sayfa 12
Kaldırma Sistemleri APlusLift MT1500 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu ve Çalıştırma Talimatları indirin. APlusLift MT1500 20 sayfaları. Motorcycle lift
Sayfayı Yazdır
I nst a lla t ion
4 .
4.2 ASSEMBLY INSTRUCTIONS
NOTE: For additional references to the parts listed in the following pages, refer to the
Assembly Diagrams on pages 12 - 14.
4.3 Determine T he Proper Lift Location:
1. Do not use the lift on any asphalt surface. Make sure the lift is used on a dry, oil/grease free,
flat, level, concrete surface capable of supporting the weight of the Lift and the equipment. Do
not use the lift on concrete expansion seams or on cracked, defective concrete.
2. Make sure to check the desired location for possible obstructions such as a low ceiling,
overhead lines, adequate working area, access ways, exits, etc.
4.4 Unpacking & Setup
Open the shipping container, then remove the ramp and shipping boards out of the packaging.
1.
CAREFU LLY T U RN TABLE U PRI GH T I N T O OPERAT I N G POSI T I ON BEFORE
2.
REM OV I N G T H E SH I PPI N G WI RE ON T H E CABLE REST RAI N T FROM
SCI SSOR M ECH AN I SM .
MAKE SURE THAT THE ROLLER GUIDES CONNECTED TO THE
3.
CYLINDER ROD ARE ON THEIR TRACKS CORRECTLY BEFORE RAISING
THE LIFT!
Connect the foot-operated air valve to 90-120 psi air supply. The lift may be damaged and/
4.
or personal injury may result if the pressure exceeds the maximum psi rating.
5.
Stand clear of the lift table, and depress the UP side of the foot valve to raise the table.
To lower the table, raise lift and then lift the safety lock bar from safety latch and lower to
6.
the next position or to the floor.
7.
Place the dropout cover over the dropout opening.
Insert the ramp mounting pins into the holes at the end of the table to mount the approach
8.
ramp.
9.
The safety lock bar can be held up by attaching it to the safety lock bar clip underneath the
table assembly.
Copyright
2020
C
www.apluslift.com
TM
Phone: 800-616-9618 Text: 425-300-2600 Email: [email protected]
APlusLift MT1500 & MT1500X
I N ST ALLAT I ON M a nua l
Route hose from here ONLY.
Otherwise clearance may not
be enough.
Figure 4.1
Mounting points for the
MT1500
&
MT1500X
ramps. Please make sure the approach
ramp is
correctly
mounting points before using the lift table.
APlusLift
approach
installed
at
all
12 of 20