Apollo 51000-355 Manuel d'installation

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Apollo 51000-355. Apollo 51000-355 16 pages. Wireless smoke heat alarm

Imprimer la page

51000-355 / 51000-357

Wireless Smoke Heat Alarm

Installation Guide

ATTENTION: This manual should be read prior to use and retained for

further information.

GENERAL INFORMATION

The Wireless Smoke Heat Alarm is a 3xAAA battery powered wireless

detector intended for use with a compatible wireless alarm system. The

detector has a built-in wireless transmitter, which communicates with the

control panel. When smoke is detected, the alarm sounds a loud local alarm

and the built-in transmitter sends a signal to the control panel. The Wireless

Smoke Heat Alarm contains an integrated fixed 41°F temperature freeze

sensor that will send a warning signal based on temperature detected. This

detector is designed to provide protection with 70-foot spacing capability.

The detector can send alarm, tamper and battery condition messages to

the system's receiver. Refer to the wireless system's instruction for the

maximum number of transmitters that can be supported.

CONTENTS OF BOX:

• Wireless Smoke Heat Alarm with base

• Installation guide (APD0601)

• Pack of screws and anchors

• Labels or decals as appropriate

• 3 AAA PC2400 Duracell Procell batteries (1.5V 1100mAh) or 3 AAA

Energizer E92 batteries (1.5V 1100mAh)

The Wireless Smoke Heat Alarm contains a sounder which generates the

ANSI S3.41 temporal 3 pattern in an alarm condition. In alarm, a message

is also sent to the control panel and the detector's ID is displayed at the

console. During an alarm condition, pressing the detector's hush button

will silence the sounder (see table below). The mounting base installation

is simplified by the incorporation of features compatible for both drywall

fasteners (not supplied) and other methods.

Tricolored LED (red, yellow, green) and a sounder on the detector provide

local visual and audible indication of the detector's status as listed in Table

During initial power-up the LED blinks alternately red, yellow then green. It

takes about 8 seconds for the detector to stabilize.

After power-up has completed and the detector is functioning normally, the

green LED blinks once every 12 seconds.

Detector Trouble: When the detector has a general fault, the yellow LED

blinks once every four seconds and there is a chirp every 48 seconds. After

12 hours the panel will display a loss of supervision message.