Duro Dyne SSFU Manuel du propriétaire - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Duro Dyne SSFU. Duro Dyne SSFU 8 pages. Adhesive applicator

Imprimer la page

OPERATION

Starting and Adjusting the Pump: (see Figure-3 below)

1 - Check that all fittings are tight. Be sure to use a compatible liquid thread sealant or Teflon tape on all

male threads. Tighten the Fluid Inlet and Fluid Outlet fitting into the Pump.

2 - Place the finished Pump Assembly onto either a 5 gallon pail or a 55 gallon drum with tubing into the

fluid. Ensure stability when placing on a 5 gallon pail.

3 - Make sure the Air Regulators are closed. Open the Re-circulating Valve.

4 - Connect the air-line quick disconnect to the Air Inlet Fitting.

5 - With the Gun Air Regulator closed, open the Pump Air Regulator.

6 - Allow the Pump to cycle slowly until all air is pushed out of the Re-circulation Tube and the Pump is

primed.

7 - Trigger the Spray Gun. Open the Gun Air Regulator and close the Fluid Drain Valve. Allow the Pump to

cycle slowly until all air is pushed out of the Fluid Hose and Spray Gun.

If Pump Fails: (see Figure-3 below)

Lower the air pressure with a 1/8" flat-head screwdriver. Give the reset valve on the front of the Pump a

1/16" turn left or right. Pump should reset and begin cycling. This may need to be repeated 2 or 3 times.

Re-circulating Line: (see Figure-3 below)

The Re-circulation Tube drains unused fluid back into the fluid container, ensuring an even flow at the Gun.

Re-circulation also provides gentle fluid agitation. Tore-circulate fluid, open the Re-circulating Valve while you

are spraying. To stop re-circulation, close the valve.

Operating Pressure:

Air.............60-70psi

Fluid..........60-70psi

Figure 3:

Black

Spray Gun

Fluid Hose

Pump

Air Inlet

Fitting

Re-Circulating

Valve

Red

Air Hose

Gun Air

Regulator

Pump Air

Regulator

Re-Circulation Tube

Suction Tube