DataBay ET-HF0101-TG200 Manuel de l'utilisateur - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} DataBay ET-HF0101-TG200. DataBay ET-HF0101-TG200 8 pages. Hdmi fiber optic extender kit (multi-mode sc type)

Imprimer la page

Installation

Important: Please use the installation procedure below. Improper or no

operation may result if the start-up sequence is not correctly followed.

Installation Step

Put 'TX' module near to HDMI signal source, such as DVD players or

computers.

Put 'RX' module near to HDMI sink, such as LCD TVs or Projectors.

Connect HDMI cable from TX to Source. Also connect the HDMI cable from

RX to Sink.

Connect each duplex SC fiber cable as indicated number. The channel "1" of

TX corresponds to channel

connection.

Plug in the 5V adaptor to the electricity and TX/RX modules.

Note 1：Clean end face of fiber before plugging in. The dust will cause damage to the fiber.

Note 2：The length of HDMI cable should be NOT longer than 2 meters.

Note 3：These three figures in front of the modules represent linking status. These 3 LEDs will be

bright greenly if all setups are complete and correct. The left one stands for the

connection of fiber. The middle one stands for the connection of HDMI source. The right

one stands for the connection of HDMI source.

Optical fiber

Figure 3 Installation of Optical HDMI extender

HDMI source cable

"1"

of RX. The other channels are the same

- 4 -

HDMI sink cable