DataBay ET-HF0101-TG200 사용자 설명서 - 페이지 5
{카테고리_이름} DataBay ET-HF0101-TG200에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DataBay ET-HF0101-TG200 8 페이지. Hdmi fiber optic extender kit (multi-mode sc type)
페이지 인쇄Installation
Important: Please use the installation procedure below. Improper or no
operation may result if the start-up sequence is not correctly followed.
Installation Step
1.
Put 'TX' module near to HDMI signal source, such as DVD players or
computers.
2.
Put 'RX' module near to HDMI sink, such as LCD TVs or Projectors.
3.
Connect HDMI cable from TX to Source. Also connect the HDMI cable from
RX to Sink.
4.
Connect each duplex SC fiber cable as indicated number. The channel "1" of
TX corresponds to channel
connection.
5.
Plug in the 5V adaptor to the electricity and TX/RX modules.
Note 1：Clean end face of fiber before plugging in. The dust will cause damage to the fiber.
Note 2：The length of HDMI cable should be NOT longer than 2 meters.
Note 3：These three figures in front of the modules represent linking status. These 3 LEDs will be
bright greenly if all setups are complete and correct. The left one stands for the
connection of fiber. The middle one stands for the connection of HDMI source. The right
one stands for the connection of HDMI source.
Optical fiber
Figure 3 Installation of Optical HDMI extender
HDMI source cable
"1"
of RX. The other channels are the same
- 4 -
RX
HDMI sink cable