Cavity Sliders SofStop Instructions d'installation - Page 2

Parcourez en ligne ou téléchargez le pdf Instructions d'installation pour {nom_de_la_catégorie} Cavity Sliders SofStop. Cavity Sliders SofStop 4 pages.

Imprimer la page

Fix the track.

CS WallMountTrack is screw fixed from the side through

the pre-machined slots in the extrusion.

Hole centers are pre-set at 406mm (16") apart.

Screw fix the track to the stud wall using #8 screws,

ensuring it is level and solid enough to support the door

weight.

Pre-machined

slots

Note: for 2" thick doors, a 6.35mm (1/4") spacer is required.

For 2-1/4" thick doors, a 12.7mm (1/2") spacer is required.

For fixing to concrete walls, the use of masonry anchors is

recommended. You may need to open the existing holes to

suit the type of masonry anchor you have selected.

Clean out all swarf and debris from the track before hanging

the door.

Fit the carriages (A, B or C).

Standard M6/M8 (non-SofStop)

Insert the carriages into the track, taking care not to damage

the wheels on the sharp edge of the track.

Single

a) The single SofStop mechanism fits together as shown

below. Push pickup mechanism in the direction shown to

charge it.

Pickup

mechanism

(push this way

to charge)

Front

carriage

M5 pan head

machine screw

b) Most of the time you will have room to slide the

mechanism in from the end of the track fully assembled.

c) If there is not enough room, remove the front carriage

(attached to the SofStop cassette).

Insert as individual components and re-assemble in the

track.

Front

carriage

Make sure the front carriage with the tow bar

connected to the soft close mechanism faces the end of

the track that you want to soft close.

(Soft Close)

Rear

carriage

SofStop

Dolly

cassette

wheel

Rear carriage

(M6 or M8)

Twin

(Soft Open & Soft Close)

The twin SofStop mechanism fits together as shown below.

Push front and rear pickup mechanisms in the direction

shown to charge them.

Front pickup

mechanism

(in charged

position)

Front

carriage

M5 pan head

machine screw

Most of the time you will have the room to slide the

mechanism in from the end of the track fully assembled.

If there is not enough room, remove the front carriage

(attached to the SofStop cassette).

Insert as individual components and re-assemble in the track.

Slide rear activator

into track first

Front

carriage

Hang the door

Position the carriages in the pocket opening approximately

where the mounting plates on the door will be located when the

door is in the closed position.

Position the door underneath the carriages. Raise the door up so

that the round head of the wheel hanger shaft lines up with the

keyhole shaped hole in the mounting plate.

Depress the plunger using the wheel hanger shaft head and slide

sideways using the adjusting wrench until it snaps into locked

position. Repeat for the other carriage.

M6 Carriage

Mounting

plate

Fit the T-Guide.

Screw the 23mm (7/8") high black plastic floor guide in the

correct location.

The T-Guide should be

concealed directly below the

front edge of the door.

Note: a 50mm (2") high T-Guide

is available if required.

Rear pickup

mechanism

(push this way to

charge)

Rear

carriage

Dolly

wheel

Rear

carriage

M8 Carriage

Plunger

T-Guide