Cavity Sliders SofStop Instructions d'installation - Page 4
Parcourez en ligne ou téléchargez le pdf Instructions d'installation pour {nom_de_la_catégorie} Cavity Sliders SofStop. Cavity Sliders SofStop 4 pages.
Imprimer la page4
10.
If you need to remove the door.
Fit the club end of the adjusting wrench over the
hexagonal nut at the bottom of the hanger pin.
Use the extended part of the wrench to press down the
plunger pin that protrudes up from the mounting plate.
Once this plunger is fully depressed slide the wrench
sideways towards the plunger pin.
The whole carriage (including the shaft) will now disengage
from the mounting plate.
It is not always easy to slide the wrench sideways.
You may need to relieve the door's weight by putting a
wedge between door and floor.
Remove the black plastic stop that is tightly fitted into the
mounting plate by tapping it out in the direction shown
using a hammer and drift.
Black plastic
stop
Tap this way
to remove
Cavity Sliders USA Inc.
548 Finney Ct, Gardena, CA 90248
Phone: (888) 466 0030
Fax: (310) 769 5824
www.cavitysliders.com
© All copyright and other property in this document is reserved by Cavity Sliders USA Inc.
Details and specifications are subject to change without notice. Whilst all care is taken to ensure
the accuracy of all information, no responsibility will be accepted for any errors or omissions.
Drawings are not to scale.
CS WALLMOUNT TRACK (O.D. 2018). 07.2019 - ZG00263 / 61318/US
Adjusting
wrench
Plunger
pin
Another quality product from: