Dataman ROV MS2200 Manuel de démarrage rapide

Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} Dataman ROV MS2200. Dataman ROV MS2200 7 pages. Laser barcode scanner

Imprimer la page

Quick Start Guide for the ROV MS2200

The configuration instructions included with the ROV are for reference purposes, all ROV

MS2200 laser scanners supplied by Dataman Barcode Systems have already been tested

and set up to work with the supplied USB cable, the ROV DOES NOT require any further

initial programming and can be used immediately.

The extra RS232 serial cable supplied with the ROV must be retained and could be required

at a later time, especially if the additional "Time Stamp" feature of the ROV is to be exploited.

The sheet of command bar codes supplied with the instructions should be studied and may

be required during the operation of the ROV MS2200, we recommend that a copy be made

and laminated to provide greater durability, the original copy should be filed for reference.

Batteries do need to be fitted as per the configuration instructions (see below). The switch on

the USB cable has already been set to the correct Kbd/HID mode.

Before using the ROV, the scanner must be powered up. If you have not already done so,

please undertake the procedures described as follows.

Use alkaline AAA batteries or NiMH rechargeable AAA batteries in your scanner.

Please remove the batteries when you store your scanner for more than 30 days

1. Press the battery cover release button, then slide and lift the battery cover.

2. Insert the batteries as shown, noting polarity.

3. To replace the battery cover, make sure that the cover tabs fit into the cover

slots, and then slide the cover until it clicks into place.

Initially the ROV MS2200 scanner will be connected to the host computer using

the USB cable included. (DO NOT connect the ROV scanner to the cable

at this point).

Note:

The Microvision USB cable sends bar codes directly to the computer's keyboard

buffer so they appear as if they were typed from the keyboard. For more information, see the

USB Cable Quick Start Guide supplied with the cable.

CONNECTION WITH USB CABLE IN HID or KBD MODE

Ensure the selector switch located on the USB cable is set to KBD.

Windows:- Connect the USB cable to a vacant USB port on your

computer, the host computer may respond with a pop up text balloon in

the bottom right of the screen indicating "NEW USB Hardware found".

Now connect the other end of the USB cable to the input port on your ROV Scanner.

Mac:- Connect the USB cable to the USB port on the Mac device. An installation wizard

appears on the screen and recognises the cable as an unknown keyboard.

Now connect the other end of the USB cable to the input port on your ROV Scanner. The Mac

wizard may prompt for a key to be pressed on the unknown keyboard, instead scan any

convenient bar code to complete the Mac installation process.

Mac & Windows:- The bar code reader is now ready to use, simply open the application that

you require to capture the bar code data and start scanning. For Windows an ideal application

to test the scanner is "Notepad", this basic editor program can be found from Start>All

Programs>Accessories>Notepad

USB cable VCOM / KBD Switch

Selector Switch on cable

VCOM

KBD