Dataman ROV MS2200 Manuel de démarrage rapide - Page 5
Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} Dataman ROV MS2200. Dataman ROV MS2200 7 pages. Laser barcode scanner
Imprimer la pageOPERATING THE ROV MS2200 BAR CODE SCANNER
Before you start scanning barcodes in HID KBD or VCOM serial mode, complete the following steps.
Firstly, scan the "RFS" control bar code followed by "ROV Download Delay 500 Milliseconds" control bar
code, these bar codes can be located on the page 4 (last page) of this Configuration Guide.
These two commands reset the ROV scanner and then instruct it to add a 500-millisecond delay between
each bar code downloaded when operating the ROV in data download batch mode.
Lastly and importantly, scan the "ROV Bar Code Prefix (STX) is False" bar code also located on page 4 of
this Configuration Guide.
This command prevents the scanner from adding unwanted data to the bar codes, for Windows
applications this stops characters in bold. For Mac applications this stops unwanted cursor movements
from being added to bar codes.
When the ROV MS2200 scanner is connected to the host computer any bar code scanned is transmitted
immediately to the computer. However, when the ROV scanner is disconnected from the cable the ROV
automatically enters into batch mode and every bar code scanned is stored in non-volatile memory.
The actual number of bar codes that can be stored in memory varies and depends upon the length of the
bar code. When the scanner's memory is full the LED blinks three times and the beeper sounds three
times. The scanner cannot perform any additional scans when it is full.
Extended Memory Capacity
Extended memory scanners contain 64KB of non-volatile memory and can store roughly 4000 bar codes.
This table shows the stored bar code capacity for specific types of bar codes
Code 128, ITF
Data that is held in the ROV scanner's non-volatile memory is automatically uploaded to the host
computer when the ROV scanner is reconnected to the interface cable if set to do so.
WARNING:
Data in non-volatile memory is automatically cleared upon data uploading, make sure the
receiving host application is prepared correctly before reconnecting the ROV scanner or the bar code data
in scanner memory could be lost.
Good Scan
Memory Full
Uploading
Upload Complete
Sleeping
Low Battery (after
good scan) or other
error
Dead Battery
Symbology
UPC-A
UPC-E
EAN-8
EAN-13
Code 39,
RSS-14
1 blink
3 blinks
2 blinks every second
1 blink
None
2 blinks
Double-blinks 3 times
Bar Codes Stored
No Timestamps
4349
6523
5930
4077
7249 (6 characters)
3624 (15 characters)
2836 (20 characters)
3837
1 beep
3 beeps
None
3 different beeps
None
2 different beeps (be-boop)
2 different beeps 3 times (be-boop)
With Timestamps
2965
3837
3624
2836
4077 (6 characters)
2609 (15 characters)
2174 (20 characters)
2718