4ms Autonomous Bassline Generator Manuel du constructeur - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel du constructeur pour {nom_de_la_catégorie} 4ms Autonomous Bassline Generator. 4ms Autonomous Bassline Generator 5 pages.

Imprimer la page

Step 8: Standoffs

Step 9: Final touches

Insert the two ICs:

The ATtiny84 has a notch on the end that matches the silkscreen "notch" on the PCB (points

•

towards the resistors).

The TL062 has a dot next to pin 1 that lines up with the "notch" on the PCB (points towards the

•

ATtiny84).

Install the finishing hardware:

Button caps x 3

•

Knob cover x 1

•

Install the tweakable resistors and caps (if you used sockets in the earlier steps)

47k x 1 (or other value between 15k and 470k)

•

0.01uF x 2 (or other value between 4700pF and 0.1uF: 0.033uF is a good one)

•

Nylon Legs:

Insert the four nylon legs into each corner hole,

and tighten them down with a nut.

You're done!!! Let's jam!