4ms Autonomous Bassline Generator Manual do construtor - Página 5
Procurar online ou descarregar pdf Manual do construtor para Placa de som 4ms Autonomous Bassline Generator. 4ms Autonomous Bassline Generator 5 páginas.
Step 8: Standoffs
Step 9: Final touches
Insert the two ICs:
The ATtiny84 has a notch on the end that matches the silkscreen "notch" on the PCB (points
•
towards the resistors).
The TL062 has a dot next to pin 1 that lines up with the "notch" on the PCB (points towards the
•
ATtiny84).
Install the finishing hardware:
Button caps x 3
•
Knob cover x 1
•
Install the tweakable resistors and caps (if you used sockets in the earlier steps)
47k x 1 (or other value between 15k and 470k)
•
0.01uF x 2 (or other value between 4700pF and 0.1uF: 0.033uF is a good one)
•
Nylon Legs:
Insert the four nylon legs into each corner hole,
and tighten them down with a nut.
You're done!!! Let's jam!