4ms Autonomous Bassline Generator Manual do construtor - Página 4

Procurar online ou descarregar pdf Manual do construtor para Placa de som 4ms Autonomous Bassline Generator. 4ms Autonomous Bassline Generator 5 páginas.

Imprimir página

Step 6: Bottom-side stuff

Step 7: Battery Snap

On the bottom side, solder:

1/4" audio jack

•

IR receiver (the black LED-

•

looking thing)

IR LED x 2 (box "sidelooker")

•

Note 1: Snip the leads of the volume

trim-pot before soldering the jack. You

only have to solder the 3 square pads

on the jack, and it's easier to solder

some of the pads from the underside

of the board.

Note 2: The long lead of the IR

receiver goes in the square hole. Bend

it over as shown in the photo.

Note 3: Mount the IR LED's so that

the "lens" faces outward.

1. Snip all the leads that will fall

underneath the battery hodler (the

TL062 socket, some nearby

resistors/caps, and the three

buttons)

2. Insert the the two metal posts of the

battery holder into the board but

don't solder it yet! Make sure it

fits more or less flush to the board

(if not, then you need to do step 1

again)

3. Line up the mounting holes with

the holes on the board (3 holes

should line up, the 4th is not

needed).

4. Insert screws from the bottom side

and fasten with nuts on the top side

of the board.

5. After tightening the screws, solder

the two leads of the battery holder.