4ms Quad Clock Distributor Expander Manuel du constructeur - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel du constructeur pour {nom_de_la_catégorie} 4ms Quad Clock Distributor Expander. 4ms Quad Clock Distributor Expander 12 pages.

Imprimer la page

Step 5: Capacitors

Insert and solder the capacitors. The 0.1uF, 0.01uF, and 20pF caps can go in either way, but the 47uF

cylinder caps must go in with the long lead in the square hole.

Above left: the 0.01 uF and 0.1uF

caps are labeled "103" and "104"

respectively on their faces. While they

look very similar, the 0.1uF (on the

left) is slightly smaller.

Step 6: Prep Mounting part 1

A. First, snap your boards apart. They are scored down the length, and you can just snap them apart with

your hands. Be careful of the male header pins, as these will poke your hands if broken incorrectly.

B. Lay the top board on the

control board so that the header

pins line up with the female

headers.

C. Gently press the boards

together. Verify that everything is

straight, none of the headers are at

an angle, and no pins are sticking

out (see photo on right).

• 0.01uF (103) x 4

• 0.1uF (104) x 1

• 20pF x 2

• 47uF x 3

• 47uF x 3 (note the stripe

orientation)