4ms Quad Clock Distributor Expander Manuel du constructeur - Page 6
Parcourez en ligne ou téléchargez le pdf Manuel du constructeur pour {nom_de_la_catégorie} 4ms Quad Clock Distributor Expander. 4ms Quad Clock Distributor Expander 12 pages.
Imprimer la pageD. Take apart the boards, then insert and solder the 10k trimpot. The trimpot goes on the opposite side of
all the other components.
E. Take a minute to carefully inspect the bottom
(control) board. Make sure every component is
soldered, and that you didn't miss a joint. It's
especially easy to miss a joint in the rows of header
pins. After the next step, locating and fixing a
problem will be harder, so take the time now to
check everything over.
Step 7: Prep Mounting part 2
A. Bend the tabs off of the 16mm pots (see photo below) with your needlenose pliers. Place one washer
on each potentiometer, this will ensure proper spacing and tightening during the mounting process.
B. Bend the tabs inward a bit, and insert the 9mm potentiometers into the PCB. Do not solder yet.
C. Insert the jacks into the PCB, make sure all pins are through their respective holes. Do not solder yet.
D. Insert the 16mm potentiometers into the PCB.
Do not solder yet.
E. Install one nut at the base of each of the four
switches (see photo above). Then insert into the
PCB.
F. Notice the LEDs come color coded on a
piece of paper. The one with milky off-white
head is white, and the other three have clear
heads. If these three become separated from the
colored sheet they will be hard to discern from
one another, so make sure to
remove one LED at a time. Insert the LEDs into
the PCB where marked. The longer lead goes in
the square hole.
G. After inserting all 4 LEDs, verify the long
lead is in the square hole. This is easy to mix
up, and hard to fix later.