DV8 OFFROAD SPEC Series Manuel d'installation - Page 10

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} DV8 OFFROAD SPEC Series. DV8 OFFROAD SPEC Series 10 pages. Rear bumper for 2018+ jeep jl wrangler
Également pour DV8 OFFROAD SPEC Series : Manuel d'installation du produit (10 pages), Manuel d'installation (12 pages), Manuel d'installation (9 pages)

Imprimer la page
DV8 OFFROAD SPEC Series Manuel d'installation
INSTALLATION
MANUAL
STEP 16 |
To use the nutsert tool,
slider the M6 washer and spacer onto the
provided M6x50 bolt.
Then install a nutsert onto the exposed
threads by hand.
STEP 17 |
Slide the nutsert tool
with the nutsert into the mounting hole.
Ensure the flange of the nutsert is flat
against the vehicle prior to tightening.
STEP 18 |
Use a 12mm wrench to
hold the spacer while tightening with
a 10mm socket. Tighten slowly until
the nutsert is set properly. Do not over
tighten.
Nutsert should be "crushed" against the
inside of the fender so that it is tight and
secure.
When finished remove the nutsert tool
using a 10mm socket and repeat as
needed.
Note: Be sure to hold the spacer tight so it does
not move and scratch paint.
NEED HELP?
855-680-9595