AUSSIE TONNEAU ATB01152 Instructions de montage - Page 2

Parcourez en ligne ou téléchargez le pdf Instructions de montage pour {nom_de_la_catégorie} AUSSIE TONNEAU ATB01152. AUSSIE TONNEAU ATB01152 4 pages. Tonneau cover to suit triple m 2400 x 1712mm

Imprimer la page

6. To fit the rope buttons. Start with the rear centre bunjis (loops), ensure the Tonneau cover is

centred and taught (this is critical). Vertically line up each rope button individually to each bunji,

squeeze the centre bunji loop together, with a marking pencil make a mark at the lower end of

the bunji. This mark is the place to drill a hole and secure the first button with a pop rivet.

Measure the distance between the top of the tailgate to the button and use this measurement

to repeat the process for the remaining buttons on the tailgate, alternating from one side to the

other. Secure the Tonneau cover to the tailgate using the bunjis as the rope buttons are fitted.

See Diagram B.

7. To fit the rope buttons to the sides of the vehicle. Vertically line up each rope button

individually to each bunji (loop) starting with both rear corners. Pull the left hand side bunji

down until the bunji and the Tonneau cover are centered and taught (this Is critical). Using the

marking pencil, mark the positions of the rope buttons. Now measure each side from the top

of the drop side to the new mark, these should be the same distance (if they are not, ensure

the cover is centered in the width and try again) Drill and rivet the 2 rope buttons to the rear

sides of the vehicle. Repeat this procedure for the remaining rope buttons. Alternate from

one side of the vehicle to the other. Secure the Tonneau cover to the vehicle's sides as the

rope buttons are fitted.

8. Note: if the side bunji nearest the front are the same length as the rest of the bunjis, the

buttons should be fitted directly in line with the front bunji. If the side bunji nearest the front

on each side of the Tonneau are longer than the side bunjis these buttons must be secured

towards the front of the tray. For example, repeat the measurement down from top of the

drop side and make a mark. From this mark, measure 65mm towards the front of the tray and

mark this point. Drill and rivet the rope button and secure the Tonneau. Repeat this procedure

for the other side of the tray.

9. Note: for Tonneaus with a front corner triangle sewn into the front LHS and RHS corners,

repeat the above process to determine the height of the bunji. Place bunji where appropriate

for specific vehicle.