AUSSIE TONNEAU ATB01152 Instructions de montage - Page 3

Parcourez en ligne ou téléchargez le pdf Instructions de montage pour {nom_de_la_catégorie} AUSSIE TONNEAU ATB01152. AUSSIE TONNEAU ATB01152 4 pages. Tonneau cover to suit triple m 2400 x 1712mm

Imprimer la page

2. CARING FOR YOUR TONNEAU

Apply bee's wax or Dri-lube to stitching a few times a year, as this will maintain the tonneau's

waterproofing ability and prevent the stitching from degrading. Use a mild detergent and soft

scrubbing brush to clean tonneau.

Never drive without tonneau support bars in place as flapping can cause a delaminating

effect on the material.

3. MULTI-FIT SUPPORT BAR

The Aussie Tonneau Multi - Fit Support Bar is designed to fit almost all Utes on the Market, from Suburu

Brumbys to Cab Chassis aluminium trays.

3.1 BASIC TOOL REQUIRED

Drill, 4mm drill bit

3.2 MULTI-FIT SUPPORT BAR CONTENTS

1 x hollow bar centrepiece

2 x solid bar end piece

3.3 FITTING MULTI-FIT BAR

1. Insert solid bar pieces into either end of hollow tube. Adjust bar so it fits between bar bracket

holders with the holes facing to the ground (so the grub screws don't rub against the tonneau),

as shown above and then with a white pencil make a mark through the small holes of the

"Tonneau is not designed to be used as a load restraint"

2 x grub screws